En-site NavX (St. Jude mapping)

Bring main and secondary NavX carts into room.

Secondary cart

• Mount magnet to table plug side towards the foot of the table

NavX magnet plug

Mounted on table

• Locate magnet cable on secondary cart and plug into magnet (arrows on plug will be toward the floor)

Magnet cable

Cable plug location

• Locate power, ground, and fiber optic cable hanging on secondary NavX cart

Power, ground, fiber

• Plug power cord into power outlet

Power

• Ground, fiber, and data cables

Ground, data, fiber cables

• Ground cable plugs into grounding block

Ground block

• Two Fiber optic cables connect as shown. Orange cables on top, gray under

Fiber optic location

• Serial data cable connects to left of fiber optic cables

Serial data cable

Main Cart

• From second drawer of main cart unpack splitter unit

Splitter unit

• Splitter unit is installed between pin-blocks and amplifier, also between ecg cable and amplifier

Splitter unit location

• Unplug A,B,C cables from amplifier

Unplug pin-blocks

• Replace with A,B,C cables from splitter
• Repeat with ecg cable
• A,B,C and ecg cables plug into splitter

A,B,C cables go here

• Colored plugs from splitter connect to St. Jude amplifier on main cart

Splitter cables

• From top drawer of main cart remove patch connection unit

Patch unit

• Secure patch unit over table control as shown

patch unit location

• Patch unit plugs into amplifier here

Patch unit plug location

• Locate power, ground, and fiber cables on side of main cart

Cables on side of main cart

• Plug in power cord

Power cord

• Clip ground to other ground cables or suitable metal object

Ground

• One end of fiber optic cable is plugged into bottom fiber port below plugs from earlier step marked "Precision"

Fiber cable plug

• Other end of fiber cable plugs into St. Jude amplifier port marked "Precision"

Precision amplifier port

Secondary cart part 2

• Identify fiber cable on back of secondary cart

Fiber cable secondary cart

• Plug this cable into fiber port on St. Jude amplifier

Fiber plug on amplifier

• Identify black Ethernet cable near Maquette amplifier marked "Abbott Ensite"
• Plug into back of Quartz unit on secondary cart

Quartz unit Ethernet plug

• From front of ablator on secondary cart, identify quad cable

Ablator quad cable

• Plug pins into C block 1-4

Quad pins in C block

• Identify large gray cable on back of secondary cart

Large secondary cart cable

• Plug into port on St. Jude amplifier

St. Jude amplifier