En-site NavX (St. Jude mapping)

Bring main and secondary NavX carts into room.

Secondary cart

• Mount magnet to table plug side towards the foot of the table

NavX magnet plug

Mounted on table

• Locate magnet cable on secondary cart and plug into magnet (arrows on plug will be toward the floor)

Magnet cable

Cable plug location

• Locate power, ground, and fiber optic cable hanging on secondary NavX cart

Power, ground, fiber

• Plug power cord into power outlet

Power

• Ground, fiber, and data cables

Ground, data, fiber cables

• Ground cable plugs into grounding block

Ground block

• Two Fiber optic cables connect as shown. Orange cables on top, gray under

Fiber optic location

• Serial data cable connects to left of fiber optic cables

Serial data cable

Main Cart

• From second drawer of main cart unpack splitter unit

Splitter unit

• Splitter unit is installed between pin-blocks and amplifier, also between ecg cable and amplifier

Splitter unit location

• Unplug A,B,C cables from amplifier

Unplug pin-blocks

• Replace with A,B,C cables from splitter
• Repeat with ecg cable
• A,B,C and ecg cables plug into splitter

A,B,C cables go here

• Colored plugs from splitter connect to St. Jude amplifier on main cart

Splitter cables

• From top drawer of main cart remove patch connection unit

Patch unit

• Secure patch unit over table control as shown

patch unit location

• Patch unit plugs into amplifier here

Splitter unit

• Clip ground to other ground cables or suitable metal object

Ground

File:STCarto11.jpg

Power and ground cables